It is an executable that you would run instead of mala.
First time you run it, you have to set it up, bay entering path and exe of mala (or whatever program you wish to run).
Also you need to tell it which output pin to use and the printer port address.
Next time you run it it should work.
When you run this file, it should turn on specified output pin, then start mala. (or whatever frontend you tell it to.)
You can edit the setup file, monmndr.set, or run setup again by entering the command monmind 1

You will need inpout32.dll in the windows\system32 folder.
You will also need a 5 VDC solid state relay attached to pin 25 (-) and any pin between 2 and 9 of the printer port.
The solid state relay will turn on the monitor. (Must be solid state, unless you use an opto isolator or transistor to turn on relay).
I threw this together real fast, so it may need debugging. I can post the source code if you want it .
You may have to enter the printer port address is decimal. The calculator in Windows can convert between hex and decimal.
And remember, wiring things to your printer port can be hazardous to your puter... so use at your own risk.
Have fun...